Power and Sound: EMPHASER Car Amps EA-MT4 and EA-MT1

When it comes to upgrading your vehicle with a compact, but powerful and good sounding amplifier, you will not go wrong with the Monolith power amps from the well established EMPHASER brand.

Power and Sound: EMPHASER Car Amps EA-MT4 and EA-MT1

EMPHASER Car Amps EA-MT4 and EA-MT1

High quality, timeless design, exceptional performance: both these new amplifiers from the EMPHASER Monolith series – the 4-channel model EA-MT4 and the mono power amp EA-MT1 – are convincing not only for their raw power, but also for their outstanding dynamics and excellent signal fidelity. Minimal distortion as well as a powerful, spatial sound are properties that distinguish these top class digital amplifiers.

At only 212 x 35 x 110 mm, the very compact amplifiers offer high performance in a small space. The extraordinary heat sink design of die-cast aluminum enables much smaller dimensions along with outstanding temperature management. In combination with the solid heat sink, the optimized class D amplifier electronics provides enormous power. With 4 x 100 W RMS into 4 ohms and 2 x 320 W RMS bridged, the EA-MT4 is a perfect power source for any car audio system. With 1 x 475 W RMS into 4 ohms and 1 x 600 W RMS into 2 ohms, the EA-MT1 will drive any subwoofer to peak performance.

Soundwise the two digital power amps are impressive. The EA-MT1 will underpin any type of music with a dynamic, stable and powerful bass foundation. The EA-MT4 offers a broad and linear amplified frequency range of 10 Hz – 55 kHz while the low distortion figures enable the music signal to develop its full potential with no loss of fine details. The > 60 dB channel separation of the 4-channel model provides for wonderful spatiality and precise placement of the musical action.

The EA-MT4 is equipped with 12 dB/oct. high and low pass filters. The filters are adjustable over a very wide control range of 20 – 4000 Hz (high pass) and 50 – 5000 Hz (low pass) so that the 4-channel model can also be used for active systems. The filters are individually selectable and can be combined into a bandpass filter (HPF + LPF). The EA-MT1 has a 12 dB/oct. subsonic filter (15 – 40 Hz) and 12 dB/oct. low pass filter (50 – 500 Hz), an integrated bass boost (0 – 15 dB at 40 Hz) and phase shift (0 – 180°) as well as bass level control. For both power amps the controls are easily accessible under the sturdy cover bearing the EMPHASER logo.

The new Monolith amplifiers have RCA and high-level inputs with auto turn-on/off for connection to car radios having no RCA output, thereby allowing both models to also be easily combined with OEM systems.

EMPHASER has been a name in the car audio sector for 25 years. The brand has become a well respected brand since middle of the 1990s for its enormously powerful subwoofers of the XTREME series, followed later by the series SPL, Linear-X, Neo-SPL and the state-of-the-art woofer E15NEO-COMP. The present range covers subwoofers, vehicle-specific Plug“N“Play component sets and classic lines of loudspeakers and amplifiers.

EMPHASER products are distributed exclusively through Europe’s largest car media specialist, the Swiss ACR AG.

Kontakt
Emphaser by ACR AG
Denny Krauledat
Bohrturmweg 1
5330 Bad Zurzach
0041-56-269 64 47
denny.krauledat@acr.eu
http://www.emphaser.com